Gaffman2
04-18-2008, 02:37 PM
I'm going to replace my 22RE motor in my 1992 Toyota truck on saturday.
Anyone know off hand the size and threads required for bolting the block to the engine stand?
buckeye1200
04-20-2008, 07:30 AM
Try one of these 2 sites, Toyota Nation (http://www.toyotanation.com/)
4Crawler.com main page (http://www.4crawler.com/)
Gaffman2
04-21-2008, 06:22 AM
Try one of these 2 sites, Toyota Nation (http://www.toyotanation.com/)
4Crawler.com main page (http://www.4crawler.com/)
Thanks, I lost a little time it was 12mm x 1.25 threads. I had 2 engine stands 1 needed 4 bolts 4 1/4" long at $6.90 each. The onther stand needed 4 bolts 3" long $5.32 at each. Two engine stands just made it easier to swap components from the old engine to the new one. The old truck is up and runnin! :clap: